Sabre 27
- Bateau REF# · 155143
- Longeur hors tout · 8.23m
- Année · 1970
- Construction · Fibre de Verre
- Coque · Quillard
- Couchettes · 6
- Moteur · 1 x gasoil 20cv, Volvo Penta MD2B ()
- Visible à · Falmouth
Ce bateau est vendu Voici d’autres bateaux à vendre
Détails supplémentaires
| Architecte | Alan Hill |
|---|---|
| Chantier | Marcon |
| Visible à | Falmouth |
| Capacité carburant | 60.0 L Total - 1 Cuve(s) |
| Capacité d'eau | 100.0 L Total - 1 Cuve(s) |
Mécanique
| Moteur | 1 x gasoil 20cv |
|---|---|
| Marque et le modèle du moteur | Volvo Penta MD2B () |
| Heures moteur | Inconnu |
| Refroidi par | Direct |
| Barre | barre franche |
| Transmission | arbre d'hélice |
| Hélice(s) | 2 blade |
| Consommation carburant (approx) | 1.0 L /hr A vitesse de croisière |
| Vitesse de croisière | 5 noeuds |
| Vitesse Max | 6 noeuds |
Engine had injectors removed and serviced 2011
Oil and Filters replaced yearly
Adverc battery charging system
Replaced alternator 2010
120 Ah domestic + 80 Ah starter. New OFF-1-2-BOTH switch.
Dimensions
| Longeur hors tout | 8.23m |
|---|---|
| Longeur flottaison | 6.75m |
| Bau | 2.80m |
| Tirant d'eau Min | 0.91m |
| Tirant d'eau Max | 0.91m |
| Deplacement | 3,258kg |
| Hauteur sous barrots | 1.80m |
| Stationnement | Au sec |
Voiles
| Grand voile à ris | - bande à ris (2007) |
|---|---|
| Génois/foc | - Enrouleur () |
| Equipement de Spi |
|---|
Genoa – sacrificial strip replaced 2011.
Kemp Mainsail – Performance Cruise – new in 2010 – very few hours of usage.
Spinnaker gear but no spinnaker
Systèmes électriques
12 batterie volts, 2 batterie(s) chargé(s) par: moteur
Construction
| Construction | Fibre de Verre |
|---|---|
| Coque | Quillard |
| Finition | Gelcoat finition |
Stainless steel pushpit mounted C-Chef barbecue (takes standard disposable barbecues).
¾ Marine Ply Storage locker for two gas cylinders behind tiller, top forms seat.
Primary winches changed for new Harken self-tailing winches.
Two bronze Harken snubbing winches installed for spinnaker handling.
Locker lids replaced and hinged, rather than loose.
New dodgers, with boat’s name.
Kemp boom with internal slab reefing lines.
Harken self tailing winch for reefing lines and main halyard.
New high capacity manual Whale Bilge Pump fitted in cockpit taking water from new strum box in bilge.
Aménagements
| Nombre total de couchages | 6 |
|---|---|
| Nombre de lits doubles | 2 |
| Nombre de lits simples | 2 |
| Cabines | 2 |
| Lavabo | 1 |
| Toilettes | 1 Toilettes (Manuels) |
New stainless steel, gimballed two burner + oven cooker.
Iroko worktop.
Iroko sink cover doubles as cutting board.
New deep stainless steel sink with new bronze through hull drain cock.
New tap fed by new Whale diaphragm pump from new 75 litre flexible tank in forward cabin.
New keyless filler cap fitted on deck for fresh water.
New heavily insulated Chest Refrigerator with compressor below sink.
2 feux(s) gaz cuisinière
Aménagements
| Cuisinière | |
|---|---|
| Grill | |
| Four | |
| Evier | |
| Frigo | |
| Rideaux | |
| Chauffage de cabine | |
| Système d'eau manuel | |
| Non-fumeurs |
New stainless steel, gimballed two burner + oven cooker.
Iroko worktop.
Iroko sink cover doubles as cutting board.
New deep stainless steel sink with new bronze through hull drain cock.
New tap fed by new Whale diaphragm pump from new 75 litre flexible tank in forward cabin.
New keyless filler cap fitted on deck for fresh water.
New heavily insulated Chest Refrigerator with compressor below sink.
2 feux(s) gaz cuisinière
Accastillage de pont
| Taud de bôme | |
|---|---|
| Capote | |
| Cagnards | |
| Amarres | |
| Parre battages | |
| Gaffe | |
| Béquilles | |
| Couvertures d'instruments |
2 winch(s) de drisse
2 winch(s) d'écoute
électrique guindeau
3 ancre(s)
(Plough, Fishermans, Danforth)
30.00m de chaîne
The rudder on Sabres are known to often have a problem such that there are mild steel tangs welded to the stainless rudder shaft – all of which is embedded within the rudder in foam and always wet or at least damp; the welds (between dissimilar metals) suffer from corrosion and are prone to break. Such a failure whilst sailing could lead to a very serious incident.
The rudder on this boat was split open last winter (2011-2012), the mild steel tangs were removed and replaced by stainless steel ones by a local marine welder. The rudder was epoxied back together and finally a layer of glass cloth epoxied onto the whole rudder.
Equipement de Navigation
| Compas | |
|---|---|
| Vitesse | |
| Log | |
| Vent | |
| VHF | |
| GPS | |
| Sondeur |
GPS can be connected to laptop to create a plotter, cards and software will be included if required
Plastimo Contest Compass, NASA Clipper Depth, GPS repeater, Wind, Log all new within last three years. Furuno GPS, ICom transceiver.
Commentaires du Broker
A sabre 27 in generally good condition overall with room for improvement, engine is original but runs like a champ, hull looks good with a couple of small gelcoat repairs, top sides about the same as the hull.
Interior wise its time to get the sewing machine out, knock up a few covers and the boat will be transformed. There are a couple of bits of headlining to replace and thats about it. Sails are good and usable and everything works apparently.
These boats are a great family starter for not much money and pretty capable. Owner retiring from sailing hence the sale.
These boat details are subject to contract.
Note: Offers on the asking price may be considered.